It is worth re-running this old post.
Before coming to you, each heater has journey of testing to come through.
The electronics are made for us in the UK by Cyclops / DJ Assembly in York. The heating coils are made at Backers in Rotherham. They are tested and certified by the manufacturer before coming to us.
Other components are sourced from reputable UK companies such as Honeywell and RS Components. All have their British Standard mark.
When bringing together the parts, we test each main component individually. Then the assembled unit is further tested. There are a suite of tests we perform to be able to give them their CE marking.
And finally, we run the heater in water for 8 hours to simulate its use and the check it one last time.
And just to make sure, there is a 12 month warranty period for additional peace of mind.
Also, the ‘4.8kW heater’ and the ‘2.4kW with Control heater’ are both serviceable and will give you a long life.
The rest is over to the customer. Think of the instructions as part of the product. The instructions must be read and no one who as not read them should use the heaters. If you ever lose your instructions, get in touch and we’ll send you some new ones.
Whilst these are relatively low temperature heaters appliances, they still have a hot metal element and should be treated with respect.
We have been making heaters for nearly 30 years, and tested 1000s of them. We know how they work and what breaks them. Keep to the following and your heater will give you long service.
We are redesigning the baptistry water heater, so in the New Year, this will only apply to 4.8kW heaters shown here.
With the 4.8kW heater, one element is the master and the other the slave. Both are independently earthed but the earth on the ‘slave’ flex will not work unless the master is plugged in and switched on. So, unless you have two PAT testing kits, it is important to get the correct plug.
To get an earth, the usual thing to do would be to touch the heating elements with the earth probe. The coil manufacturer advises that a contact should be sought at the base of the coil (see the photograph).
The 4.8kW water heater has two plugs and we mark the flex for the master element with a piece of black tape so you get the correct plug. Then one needs to make a test on both elements (at the base of the element). Even then, scale on the elements can give a false fail, and I have found that the ‘pencil-like’ earthing probe doesn’t get enough contact. Most kits come with an alternative ‘dog-tooth’ clamp fitting to go on the end of the earth probe.
To get at the coils, unscrew the 4 corner screws and lift out the top plate (picture 1). The coils are attached to this and should lift up with it. Use the clamp to scrape away at the scale and get a better contact.
Summary – Use the plug with black tape on flex, and get a good contact on the coil.